Revolution Gear & Axle Ring & Pinion Set for Dana 60 Reverse Rotation Front Axle (4.10 Ratio)

This Revolution Gear & Axle ring and pinion is built for Dana 60 reverse-rotation differentials in a 4.10 ratio, the high-pinion front gearing used in many heavy trucks and 1-ton axle swaps. It is the gear set on its own.

The set runs a 29-spline pinion and a 9.75 inch ring gear in 8620 alloy steel with a 41x10 tooth count, cut and heat treated to meet or exceed original equipment standards. The Dana 60 carrier break is 4.10/4.56, so this 4.10 fits the numerically lower carrier – verify your carrier before ordering.

A 4.10 is a versatile ratio that pairs well with larger tires on heavy rigs, balancing highway manners against off-road and towing capability. Because it is reverse rotation, it belongs in a front (high-pinion) housing.

This is a gear set only. Setup bearings, crush sleeve, shims and pinion seal are sold separately, and no carrier or locker is included. Pair it with a Revolution Dana 60 master install kit and have a qualified installer set pinion depth, backlash and preload.

Backed by a 2-year warranty against manufacturing defects, this reverse-rotation set is a strong choice for regearing a Dana 60 front axle.