Revolution Gear & Axle Ring & Pinion Set for Dana 60 Standard Rotation Axle (3.54 Ratio)

This Revolution Gear & Axle ring and pinion is built for Dana 60 standard-rotation differentials in a 3.54 ratio. It is the gear set by itself, a strong OE-style replacement or numerically low ratio for heavier trucks and SUVs.

The set uses a 29-spline pinion and a 9.75 inch ring gear in 8620 alloy steel, cut and heat treated to meet or exceed original equipment standards. With a 46x13 tooth count, it cross-references OE numbers 660069-5, 24813-5X, 74948-5X and 75185-5X. The Dana 60 carrier break is 4.10/4.56, so this 3.54 runs on the numerically lower carrier – verify yours first.

A 3.54 keeps engine speed down at highway pace, making it a fit for tow rigs and heavier vehicles running moderate tire sizes rather than tall off-road tires.

This is a gear set only. Setup bearings, crush sleeve, shims and pinion seal are sold separately, and no carrier or locker is included. Pair with a Revolution Dana 60 master install kit and have an experienced installer dial in pinion depth, backlash and preload.

Backed by a 2-year warranty against manufacturing defects, this is a reliable gear set for refreshing or regearing a Dana 60.