Revolution Gear & Axle Master Install Kit for Jeep (2018-26) Wrangler JL, Dana 35 (200MM) Rear Axle

This is a master install kit for the rear Dana 35 (200MM) in 2018-26 Jeep Wrangler JL Non-Rubicon models. It provides the bill of material to overhaul the differential when installing a new ring and pinion.

The kit uses Timken pinion and carrier bearings and includes a crush sleeve, carrier and pinion shims, pinion seal, ring gear bolts and cover gasket/silicone. Note that axle bearings and seals are not included – this kit covers the differential setup, not the axle shaft bearings.

This is the kit to buy alongside a new gear set when regearing the JL Dana 35 200MM rear axle, or when refreshing a worn differential. Installers rely on these kits for a clean, consistent setup.

The ring and pinion gears are sold separately; this listing is the install and bearing kit only. Differential setup is a precision job, so plan to have an experienced installer set pattern, backlash and pinion depth, and source axle bearings and seals separately if needed.

Pairing a new Revolution gear set with this master install kit gives you the differential bearings, seals and small parts needed for a complete JL Dana 35 rear overhaul.