Diamond T Enterprises 10 Lug Dually Wheel Adapters, Ford (1999-04) F-350/F-450/F-550 Dually (front & rear) (8 on 170)
These are for the 8 studs on 170 which is the common size. Some F-450/F-550 trucks had 8 on 225, this would not be the correct set for 8 on 225.
Adapters are designed and manufactured in the USA!
-Includes lugnuts for the 40 Ten lug pattern.
-Front studs are about 2.25" long
-Rear studs are about 3" long
-Loosen and remove factory lug nuts.
-Remove existing wheel and tire assembly
Step 2: Attach the adapter to the factory 8 lug hub assembly
-Please note front and rear adapters are different confirm before installation.
-Adapters must fit flat against the vehicle's hubs. Remove any rust and dirt from the hubs of brake rotors and drums. Remove any temporary retaining devices, like stud clips, they may interfere with the flush fitment of your adapters against the brake hubs.
-Using the factory flat washer lug nuts, use an air gun or torque wrench to torque the factory flat washer lug nuts to 140lbs on to the adapter. -After tightening all 8 factory lug nuts to the adapter, inspect the installation.
-Make sure the adapter is sitting secure and flush with the hub of the truck.
Step 3: Install your 10 lug wheel
-Attach the 10 lug wheel to the adapter and slide it on to the large hub of the adapter.
-Using an air gun or torque wrench, torque the large 10 bolt lug nuts to the wheel.
-After tightening all 10 large lug nuts to the wheel, inspect the installation.
-Make sure the wheel is sitting secure and flush with the hub of the adapter.
- Item Requires Shipping
- 126.0 lbs.
- Free Shipping!
Total Reviews (1)
Reviewed by: Adam08/11/2013 06:35PM
Product ownership: Less than 1 month
Purchased from: KT Performance
Great product, well built, and look great!
You must login to post a review.