PPE Silicone 45-Degree Elbow - 1.875" ID (Universal)
- 45-degree silicone elbow – a pre-formed bend for routing charge-air or intake plumbing around corners.
- Size – 1.875" inside diameter, 45-degree bend.
- Universal fit – connects tubes and couplers that need a clean 45-degree change of direction.
- Silicone build – resists heat and vibration far better than standard rubber.
- Holds its shape – the molded bend won’t collapse or kink like a bent straight hose.
- Pairs with clamps – use with clamps sized to the 1.875" connection at each end.
- Backed by PPE – covered by a 1-Year Limited Warranty.
Description
This is a PPE silicone 45-degree elbow with a 1.875" inside diameter. It’s a molded bend used to route intake or charge-air plumbing through a 45-degree turn without kinking.
Because the bend is molded in, the elbow keeps a smooth, full-diameter path around the corner – unlike forcing a straight hose into a bend, which pinches and restricts flow. Silicone construction handles underhood heat and vibration well.
It’s a common building block for custom intakes, intercooler piping and turbo plumbing where you need to connect two tubes at an angle. Match it to 1.875" tubing or couplers at both ends.
Clamp each end with a clamp sized to the connection, seat the hose fully on the tube beads, and check for leaks after a few heat cycles. Backed by a PPE 1-Year Limited Warranty.
Warning: Cancer and Reproductive Harm - www.p65warnings.ca.gov
Details
- 515181845
- 515181845
- 840171210750
- Pacific Performance Engineering
- New
Shipping Information
- Item Requires Shipping
- 0.3 lbs.
- W3.0000” x H2.3700” x L5.2600”
Customer Reviews
Total Reviews (0)
You must login to post a review.
Write the First Review!