PPE Turbo Oil Feed Gasket for Chevy/GMC 6.6L Duramax
- Turbo oil feed gasket that seals the oil supply where the feed line meets the turbocharger on GM 6.6L Duramax applications.
- Direct replacement for a hardened, crushed, or weeping factory feed gasket during a turbo install or service.
- Keeps pressurized oil headed to the turbo center bearing instead of seeping onto the block or manifold.
- Thin, flat profile that seats cleanly against both mating surfaces for a reliable seal.
- Fits Chevy/GMC 6.6L Duramax turbo oil feed setups – compare it to your old gasket before ordering.
- Sold individually as a service gasket, not a complete turbo gasket set – grab any other seals your job needs.
- No warranty on this consumable sealing component, as listed by PPE.
Description
This is the PPE turbo oil feed gasket for Chevy/GMC 6.6L Duramax trucks. It seals the joint where the oil feed line delivers pressurized oil to the turbocharger, and it’s the small part that quietly makes or breaks a clean turbo install.
It’s a single, thin sealing gasket sized for the Duramax turbo oil feed fitting. Anytime you pull the feed line – a turbo swap, a bearing service, or chasing an oil leak – this is the gasket that goes back on so the connection seats flat and leak-free.
Reuse an old, crushed feed gasket and you invite an oil weep at the fitting, which makes a mess and can starve the turbo. Replacing it with a fresh gasket is cheap insurance for a repair you don’t want to open back up.
Note this is a service gasket only, sold on its own and listed with no warranty. Confirm it matches your existing feed gasket, and order any additional turbo seals or hardware you need to finish the install in one pass.
Warning: Cancer and Reproductive Harm - www.p65warnings.ca.gov
Details
- 116005017
- 116005017
- 840171207781
- Pacific Performance Engineering
- New
Shipping Information
- Item Requires Shipping
- 0.0 lbs.
- W0.2500” x H0.1000” x L2.3700”
Customer Reviews
Total Reviews (0)
You must login to post a review.
Write the First Review!