Edge Products EAS Competition Kit, EGT/Boost/Temp Sensors (CS2/CTS2/CTS3)
- Full sensor package: Adds EGT, 0-100 PSIG pressure and -40 to 300 F temperature readings to your Edge monitor.
- Kit contents: EAS Starter Kit, EAS EGT Probe, EAS Universal 5 Volt input, EAS 0-100 PSIG Pressure Sensor and EAS -40 to 300 F Temperature Sensor.
- Boost beyond stock: The 0-100 PSIG sensor reads boost an aftermarket turbo makes past the factory MAP sensor's range.
- Temps where you need them: Use the temp sensor on transmission, axle, oil, coolant or intercooler air.
- Monitor compatibility: The included EAS components are listed for Edge CS2, CTS2 and CTS3 monitors.
- Made for modified trucks: Aimed at upgraded-turbo builds and trucks that run the dyno, sled pull or drag strip.
- Clean install: EAS modules daisy-chain under the hood, and only one cable comes into the cab.
- Wiring included: All required harnesses for the included sensors are in the kit.
- Install note: The EGT probe usually requires drilling and tapping the manifold, and pressure/temp sensors need suitable 1/8 in. NPT ports.
Description
The Edge EAS Competition Kit bundles the core Expandable Accessory System sensors for a modified diesel. It puts EGT, an additional 0-100 PSIG pressure reading and a -40 to 300 F temperature reading on your Edge monitor. The included EAS components are listed for Edge CS2, CTS2 and CTS3 monitors.
Inside: the EAS Starter Kit, an EAS EGT probe, the EAS Universal 5 Volt sensor input, an EAS 0-100 PSIG pressure sensor and an EAS -40 to 300 F temperature sensor, with the wiring harnesses to connect them. The universal input has two channels, which covers the pressure and temperature sensors in this kit.
This kit is for trucks that have outgrown the factory sensors: compound or bigger single turbos, built transmissions, and trucks that see the dyno, sled pull track or drag strip. Watch boost past the stock MAP range, keep tabs on EGT during a pass and track trans or oil temp on the way back to the pits. It works just as well on a heavy tow rig.
The EGT probe usually requires drilling and tapping the exhaust manifold (bit and tap not included), and the pressure and temperature sensors need 1/8 in. NPT ports in the locations you choose. Sensor setup is done through the monitor.
If you want two of everything for logging and tuning, step up to the Datalogging Kit (98618).
WARNING: This product can expose you to chemicals known to the State of California to cause cancer and reproductive harm. For more information go to www.P65Warnings.ca.gov.
Video
Detail
Detail
Detail
Detail
Detail
Details
- 98617
- 98617
- 810115012320
- Edge Products
- New
Categories
Shipping Information
- Item Requires Shipping
- 1.5 lbs.
- W6.2500” x H2.8000” x L9.5000”
- Free Shipping
Customer Reviews
Total Reviews (0)
You must login to post a review.

Write the First Review!