S&B Replacement Fuel Tank, Ford (2017-21) F-250/F-350 6.7L Power Stroke, Crew Cab Short Bed (60 Gallon)

S&B Replacement Fuel Tank, Ford F-250/F-350 6.7L Power Stroke, Crew Cab Short Bed (60 Gallon)

Take your 2017-2020 Ford 6.7L Power Stroke Crew Cab, Short Bed further down the road on a tank of fuel by replacing that small 34 gallon stock fuel tank with a massive S&B Tanks 10-1004 60 Gallon Midship Replacement Fuel Tank. S&B has really thought of it all with this tank design. First, the tank is molded to allow for maximum capacity as well as clearance, contouring to allow for full driveshaft travel without any obstruction or possibility of rubbing. A common issue with large capacity tanks is fuel sloshing. S&B cuts down fuel sloshing with the addition of internal baffles midway through the tank.
Was: $1,498.99
Sale: $1,249.00
Save: 17%
Save: $249.99

Free Shipping


Looking to run a sump with this tank? Well, S&B is way ahead of you by integrating a sump right into the tank. You heard right, there's no need to drill a big hole in the bottom of your new tank. Just remove the aluminum plug, drill and tap a 5/8" hole and you're ready to plumb right into your fuel system using the supplied fittings that follow the channel in the tank. Sticking with an easy to install theme, your factory sending unit requires no modification for installation, just drop it in following factory procedures. Both the vent and rollover vent are made from brass as well as the transfer pump fitting which gives you the ability to draw fuel directly from the tank instead of putting an additional fuel tank in the bed (transfer pump coming soon). If your factory fuel tank came equipped with a skid plate, it may be reinstalled on the bottom of the new S&B tank! Backed by S&B's limited lifetime warranty.

• 60 Gallon Capacity
• Anti-wave Internal Baffles
• Reuses Factory Sending Unit
• Integrated Transfer Pump Fitting
• Patent-Pending Integrated Fuel Sump
• Double Coated Stainless Steel Hardware
• High-Density Crosslink Polyethylene Construction
• Direct Bolt-In Installation - No Modifications Needed
• Install can be done in 2-3 hours and does not require any cutting, drilling, or modification.

Fits Crew Cab, Short Bed models only.

*According to the Ford TSB 17-0046. If your truck has a build date prior to 3-20-17. Replace the fuel Level Sender Resistor Card Assembly with Ford part # HC3Z-9A299-N.



Shipping Information

  • Item Requires Shipping
  • 77.0 lbs.
  • W20.0000” x H22.0000” x L80.0000”
  • Free Shipping

Customer Reviews

Comment Total Reviews (0)

Write the First Review!

You must login to post a review.