PPE 3.0" to 2.5" Silicone Reducer Coupler (Universal)
- Silicone step reducer – joins two different tube sizes in a charge-air or intake run
- Sizing – 3.0" to 2.5", 5" length, 6mm 5-ply construction
- Universal fitment – fabrication piece for custom plumbing
- 5-ply strength – multi-layer silicone resists ballooning under boost
- Handles engine-bay heat – outlasts rubber in high-temp locations
- Pairs with T-bolt clamps – clamp each end for a leak-free seal
- 1-year limited warranty – backed by PPE
Description
This is a PPE silicone reducer coupler that steps from 3.0" down to 2.5" over a 5" length. It’s a universal piece for transitioning between two tube diameters in a charge-air or intake system.
It’s built from 6mm, 5-ply silicone, so it holds boost pressure without swelling and takes underhood heat far better than rubber. Use it to mate mandrel-bent tubes or components of different sizes.
Slip it over each tube, center the coupler, and secure both ends with properly sized T-bolt clamps. Match the coupler ends to your tube ODs for the best grip.
It’s a common building block for intercooler plumbing and intake fabrication, and it’s backed by a 1-year limited warranty.
Warning: Cancer and Reproductive Harm - www.p65warnings.ca.gov
Details
- 515302505
- 515302505
- 840171210224
- Pacific Performance Engineering
- New
Shipping Information
- Item Requires Shipping
- 0.5 lbs.
- W3.5000” x H3.5000” x L5.2000”
Customer Reviews
Total Reviews (0)
You must login to post a review.
Write the First Review!