Revolution Gear & Axle Ring & Pinion Set for Toyota 9.5" Land Cruiser (1969-90) (4.56 Ratio, 27-Spline)

This is the Revolution Gear & Axle ring and pinion set for the Toyota 9.5-inch Land Cruiser axle in a 4.56 ratio with a 27-spline pinion, fitting 1969–90 Land Cruiser models. It is a direct gear replacement for the classic 9.5-inch axle.

The set is machined from 8620 alloy steel and heat treated to meet or exceed OE standards. It uses a 27-spline pinion and a 9.5-inch ring gear in a standard rotation cut, with no carrier break in this application.

A 4.56 is a deep, practical ratio for vintage Land Cruiser owners running larger tires who want to restore low-end pulling power and crawling ability lost to bigger meats. It is a frequent regear choice for these classic rigs.

This is a gear set only. It does not include bearings, a crush sleeve, shims, or a pinion seal, and it does not include a carrier or any traction device. Match the ratio front and rear and plan on a master install kit for setup.

Pair it with a matching Revolution Gear master install kit for the Toyota Land Cruiser axle to get the bearings and setup hardware, and have an experienced installer dial in the pattern and preload. Gears carry a 2-year warranty against manufacturing defects.