Diamond T 10 Lug Super Single Wheel Adapters, Chevy/GMC (2011.5-13) 2500 (front & rear) (8 on 180mm)
Adapters are designed and manufactured in the USA!
Includes lugnuts for the 40 Ten lug pattern.
Chevy vehicles come with lugnuts for the 32 Eight lug pattern and all other makes use factory washer type lug nuts.
***Super Single adapters might need a spacer to give you enough clearance for the brake calipers. Some trucks work fine without spacer. We do offer 2" high grade steel spacers if you need them. These adapters will not work with inside offset wheels, only center and outside offset wheels will work.*****
*Will not fit American Force Wheels
-Loosen and remove factory lug nuts.
-Remove existing wheel and tire assembly
Step 2: Attach the adapter to the factory 8 lug hub assembly
-Please note front and rear adapters are different confirm before installation.
-Adapters must fit flat against the vehicle's hubs. Remove any rust and dirt from the hubs of brake rotors and drums. Remove any temporary retaining devices, like stud clips, they may interfere with the flush fitment of your adapters against the brake hubs.
-Using the factory flat washer lug nuts, use an air gun or torque wrench to torque the factory flat washer lug nuts to 140lbs on to the adapter. -After tightening all 8 factory lug nuts to the adapter, inspect the installation.
-Make sure the adapter is sitting secure and flush with the hub of the truck.
Step 3: Install your 10 lug wheel
-Attach the 10 lug wheel to the adapter and slide it on to the large hub of the adapter.
-Using an air gun or torque wrench, torque the large 10 bolt lug nuts to the wheel.
-After tightening all 10 large lug nuts to the wheel, inspect the installation.
-Make sure the wheel is sitting secure and flush with the hub of the adapter.
- Item Requires Shipping
- 126.0 lbs.
- W14.0000” x H7.0000” x L28.0000”
- Free Shipping
Total Reviews (0)
Write the First Review!
You must login to post a review.